RRP Proguard V2 Rear Cable Tie - Black

The ProGuard is RRP's amazing new range of front and rear mudguards for disc brake mountain bikes offering unmatched protection from mud and spray, it’s perfect for Trail, Enduro or Downhill racers and essential for the weekend warrior looking for the very best protection. RRP's design intent was to increase the tyre clearance, improve fit, and reduce the mud clogging issues seen with this type of mudguard. The ProGuard Mini Rear is primarily designed to protect your shock, linkages and bearings from getting hammered at high velocity from mud and spray off the back wheel, it’s not designed to protect the rest of the bike or the rider. There are multiple fitting options via snap-off holes and wide holes on the arms that allow for angle adjustment for various seat stay configurations.

The ProGuard range of mudguards have a soft high gloss finish which is a characteristic of RRP's highly polished mould and their special polypropylene mix, this unique mix has been specifically blended for:

• Cold weather strenth
• High impact resistance
• High flexibility
• High Durability

As a result of achieving the above properties it means that the surface layer is soft and will scratch easily, you must also be careful about putting any chemicals onto the surface as it may tarnish the finish. That said RRP has tested and can recommend the following chemicals to use:

• Silicone - Spray high-quality silicone onto the surface and very gently remove it with a clean cloth to maintain a high gloss finish and to stop dirt and water from sticking.
• Bike cleaner – Non-caustic bike cleaners can be used on the ProGuard mudguard
• GT85/WD40/Solvents - Only rub these on the surface if you want to remove the gloss and display a matte finish to match your bike.

The ProGuard - REAR mudguard is designed to help protect your shock, linkages and bearings from getting hammered at high velocity from your back wheel.

Features:

• 43 snap-off top holes to fit straight braces between the seat stays, raised braces or dropped braces including those with supporting struts
• Indent to create 4mm of additional tyre clearance (also fits the large raised brace on the Merida e-bike)
• Side arms designed to fit conventional seatstays (that go to centre of wheel), and offset seatstays (raised up from the centre of the wheel)
• Recess to protect sticker allowing you to match the sticker on your ProGuard Front mudguard
• Made of the same thick Polypropylene material used on the ProGuard Front
• Same gloss finish as the ProGuard Front (you can easily make the guard a matte finish if you prefer by spraying GT85 on it (after applying any stickers)
• 6 cable ties are provided - the holes on the side arms are mandatory requiring 4, leaving the other 2 for the fork brace (although more could be added if desired)

Specs:

• Length: 325mm long
• Weight: 64g (without cable ties)
• Wheel size: 26” 27.5” 29”
• Max tyre width: up to 3”